Are bolts the same grade as nuts? 대한민국

Bolts and nuts are the most widely used fasteners in mechanical engineering, often used to fasten two or more parts together. When selecting bolts and nuts, in addition to considering specifications and materials, you also need to understand their grade and performance to ensure safe and reliable use.

The grades of bolts are divided into more than 10 grades such as 3.6, 4.6, 4.8, 5.6, 6.8, 8.8, 9.8, 10.9, and 12.9. Among them, bolts of grade 8.8 and above are high-strength bolts, mostly made of low-carbon alloy steel or medium-carbon steel, and have been heat treated. And the rest of the bolts are called ordinary bolts.

Corresponding to bolts are nuts, which also come in different grades and specifications. Traditionally, nuts are divided into three types based on thread thickness: fine, ordinary, and thick. Among them, ordinary nuts are divided into three grades: A, B, and C. In recent years, two types, Type I and Type II, have been added based on actual needs. Hexagonal nuts are divided into three types according to their nominal thickness: type I, type II, and thin type. Nuts above grade 8 are divided into two types: type I and type II.

Different types of nuts also have their corresponding national standards, such as GB41 hexagonal nuts, GB6170 hexagonal nuts, GB6174 hexagonal thin nuts, etc. The grade of nuts is generally the same as or slightly lower than the grade of bolts to ensure the safety and stability of bolts and nuts when used together.

When selecting bolts and nuts, they need to be matched according to the actual situation. Generally, bolts and nuts should be of the same grade to ensure their suitability for tightening. However, in some special cases, because bolts are easy to replace but nuts are difficult to replace, cost and safety factors must also be considered, so the grade of nuts may be slightly lower than that of bolts.

In short, bolts and nuts are very important fasteners in mechanical engineering. When selecting, their grade, material, and specifications need to be considered to ensure their safety and reliability. In actual use, regular maintenance and replacement are also required to ensure the normal operation of machines and equipment.